@elbee said in And Suunto does it again: mid-activity crash on Suunto Race: @wakarimasen But to say the ones who do not post don’t have any problem is a bit too simple. There are people who have problems but aren’t bothered by them. Or they simple don’t know there is a forum. They might complain on strava that their watch crashed. Just under a 1000 forum members (according the to numbers in the various groups)

@Ze-Stuart This is really crazy. Suunto, what happened to your devices…!?

@megaphylls said in Watch rebooted during an activity (HM): software 3.19.16 Just like it was with me: https://forum.suunto.com/post/170416

@elbee said in Track Mode: It’s probably the track isn’t an official athletics track. Trackmode doesn’t make gps more accurate. It just snaps you gpx to what it thinks is the track. Yeah, understood. I don’t know the precise dimensions of the track. I know that the IAAF permits three non-standard dimensions, including double-bend 400 meter tracks. I believe (but don’t know for certain) that this track is a double-bend with a 97.256 meter straightaway and inner curves of 102.744 meters. This is the common alternative for tracks that enclose an American football field. I don’t understand the need for trackmode. I do tracktraining every week at my athletics club. We usually do interval training with intervals between 200 and 800 meters. There are marks all over the track, so knowing the distance is easy. Also, there are tables with times you have to run for each interval, depending on your 5k or 10k time. All you really need is a stopwatch. If the athlete is using GPS for pace and distance, then the advantage of track mode is getting precise measurements without the GPS wiggle. If your coach assigns 25×400m reps at a specific pace, track mode ensures the recorded pace accurately reflects the execution. With that said, if you are using a foot pod rather than GPS for pace and distance, such as Stryd, then track mode is unnecessary as the pace and distance will be accurate from the foot pod’s calibration. The GPS track in that case is just a breadcrumb of where you were, but isn’t part of the pace/distance calculation. Regardless, having the right dimension helps the coach know if you started your kick on the bend (as in the case of 400 meter tracks with 84.39 meter straights) or if you started on the straight. This might be valuable information to have if the track is outdoors and it’s windy. Sure, it’s nice to have your training recorded and some people might be annoyed if their interval is reported as 420m iso 400. But for your traning is doesn’t make any difference. And even the snap to lane 1 isn’t right. There are other people training or you run in a pack and you cannot always be in the inner lane. Many days when doing reps on the the track, I’m alone. Usually when I run with a club, it’s long runs on the weekend, not track sessions in the morning/evening (although I know they exist).

@herlas said in Firmware 3.19.16: threshold measurement by Suunto ZoneSense How can I do this? Where can I find it? Edit: Ah, I think I found it. The info icon in ZoneSense under the workout. Max. HR remains the same, but the zones are adjusted slightly. Do I really have to adjust the individual zones manually? Should I do that? Should I observe and compare it over several workouts first? There seem to be some strange values, as discussed here: https://forum.suunto.com/post/169683

@Ecki-D. I use custom timers loads & it is a bit pants that they aren’t remembered by the watch

@Dimitrios-Kanellopoulos I’m still experiencing the same issue. After about two weeks without a reset, my watch starts showing black tiles in locations that previously worked fine, particularly at zoom levels of 200m and below. These tiles refuse to load, even after waiting for several minutes. [image: 1752474401443-20250714_081320.jpg] Curiously, the very same map tiles will load correctly if I physically move about two km away from the problematic location and then pan the map back to check. A soft reset resolves the problem, but it always returns after another couple of weeks. This strongly suggests an ongoing issue with the map cache.

My activities are still not syncing despite all the recommendations