@Jacobus
some maths to do
https://forum.suunto.com/post/154968
14.87km and 4h 48min

@sartoric
Thank you very much for the reply. I will probably do it that way.

@C5032005 I will mirror what @iterumtenta said and I have seen similar when the Suunto HR belt is connected to my phone. It is almost like a scavenged resource where the phone and Vertical compete for the signal.

If I “forget device” of the belt from my phone I get very clean results to my watch.

@ikda12 No, there is not.

@Ales-Zavoral 100m is certainly not too far in any mountains, forest, etc. Not everyone walks/cycle in the city.

@GiPFELKiND I am on iOS and it works fine, The watch must not be syncing and have a green check to create custom sport mode. When you open the app it may immediately start syncing so be patient.

@Naiden
no…
your buttons are stiff?
compared to which models buttons?

@Valdis-Liberts this is already discussed in another thread
https://forum.suunto.com/post/120467

@markman8

@markman8 said in Last pool length memory recall:

Right now it goes back to 25m for metric settings.

Sorry for the wrong info. It did go back first time that I set it to 20m for some reason. It did not happen from there onwards. It correctly keeps the last session’s pool length that it was set.

I agree. While on a night ride I discovered the backlight options were either on or off!! Suunto, please introduce a graduated backlight with maybe 3 or 4 brightness settings. This means the watch face could be seen at night, but not put too much strain on the battery.

@BrunoH at least the bezel size isn’t the only problem anymore 🙂

@greku I agree that could be an useful feature, but at least on my garmin you edit the name after.
But if the suunto vertical is like old devices which only allows one sensor of the same type then there is little point on editing the name after (I guess).

got myself a bunch of these:
https://www.ebay.de/itm/393573658832

only issue with 3rd party straps: the pins that hold them in place in the lugs of the watch are of smaller diameter than the original Suunto ones.
Have not had any failure yet though…

@Rokelly are you in contact with support already? If not, send me the email you use for Suunto App and the time you sent the logs in a PM

@Ultrarunner you can upload routes in GPX, or create them in the app, or send them from Strava, Komoot, etc. You can follow TP workouts, the watch beeps and vibrates at the beginning of a step. Stryd works, also the native wrist power, and you can use power workouts (natively, this is one thing that Suunto supported much earlier than Garmin).

@GiPFELKiND and recovering is when my heart rate is over 90 bpm!? Suunto what is the Problem… I dont understand this measurement… Please explain how this should work… My rest hr is setting on 58… How could it be that i am recovering on this 90 HF

@GiPFELKiND said in GPS Signal suddenly wrong Position:

Should i stop a workout/ make pause when i going in a rooms, market etc?!

yes 🙂

imagine your watch always needs to see the sky. trees are already a challenge but good devices can handle it. what you do is basically flying blind and you expect your watch to know exactly where it is after it lost satellite connection for several minutes.