@MichlWe at your convenience you can also use the S+ Climb app which reports grade, ngp, vertical speed (m/h), and total vertical ascent/descent… …oops sorry I’ve missed you already talked about it

@Martin-Tuharský Known issue after the last firmware update. Until Suunto fixes this, there is a workaround: https://forum.suunto.com/topic/9751/unable-to-disable-wrist-hr-on-sport-mode?_=1703677843804

@SuperFlo75 Just bored, maybe it will be an inspiration.

@Mff73 After updated my map i did go out and hike for few hours. When i scroll / zoom out it will have some black tiles but it will gone within milliseconds. Just now i do power off and turn it on again but contour lines 500m and trails are still there Maybe you try power off and turn it on again instead of soft reset.

@Mads-Hintz-Madsen I’m hoping so too!

@Stoke80 I use LightBlue but I guess there are plenty of apps that can read the battery level.

@Egika Unless a device follows at least the specification for usb 1.0 (which includes power negotiation for up to 500mA @ 5v) it isn’t allowed to use the USB logo or branding. A chip to handle the spec costs no more than a few pence these days so it’s highly unlikely you’ll buy a charger carrying the usb branding that doesn’t follow the spec. You could pretty easily test whether a charger does actually do the handshake by sticking a little tape over the 2 middle pins of the USB-A plug or socket as these are the D+ and D- data pins needed for the handshake. If your device doesn’t start charging or takes days to charge you can, I think, conclude it’s only receiving the default 150mA.

@Igorillo you are in the options screen before starting a run - using the auto lap selection here you can set distance or duration auto laps - or turn it off. This is not the log book. In the log book when you select an activity and scroll down to the auto lap (if you have it enabled) you can right arrow to see the laps recorded. I have confirmed all of this on my SV.

@surfboomerang in my experience, of course still recording. 1 morning i woke up and go to toilet. my watch show me morning report. then go back to my bed and browsing phone a while and then take short sleep again. i woke up and my watch and app show my sleep duration was added few more hours. awake duration is quite accurate. SV know when i wake up go to toilet haha. the time i go to toilet is still under my sleeping time that i set in my watch. when my heart rate dropped below rest heart rate it will assume that i go back to sleep again. so i guess this is the reason why SV extend our sleeping duration.

@peegee for me, sleep on Suuntos is working very well for last 5years. Yesterday, after update it showed 2h awake time I hope that was just a hiccup

@thanasis No that is a tag added when you touch a vo2max zone

@Jyrppis no idea. Once I switch off 24/7 HR monitoring the LED go off and stay off, no matter where I place the watch…

@6294946 You are on 17.2 for the phone? I would download the beta app, it is unlikely to have issues. Try two things, first disconnect the watch from the phone, forget the watch in the app and then forget the app in the watch. Uninstall the app from the phone. Download the beta app or if you prefer the store app. Repair the watch. Sometimes for me the watch is not connected in the iPhone BT settings. if that occurs to you simply touch the watch in the BT settings and it should reconnect. I have reported this issue to Suunto.