I used webchat yesterday but support were only able to suggest things I’d already tried (holding the upper button for longer etc). So I submitted a service request and my watch has just been collected from my home. Very efficient so far, hopefully the repair/replacement will be as efficient. I examined the watch carefully and noticed some very small bubbles between the right-side charging connector and the centre sensor. Not as bad as some of the reports on the forum, but I wonder if this is a result of water ingress. I’ve used the watch a lot since I got it in January - about 400hr of recorded activities - and the only recent change is using it for pool swimming 2-3 times per week (whereas only used a couple of times for swimming in the first 6 months).

@omunoz fantastic. I had something similar for my Ambit3 back in the golden age of technology. Really looking forward to seeing this published.

@isazi exactly this. I have written something about it before: https://forum.suunto.com/topic/8287/mermaid-and-snorkeling-for-older-watch/6

@zhang965 ok, thank you!

@suzzlo There might be some ‘fine-tuning’ needed in the algos as well. I too can confirm that the OHR on the SV while biking (even easy commute without much grip or bouncing gives too low HR, while AW8 is spot on). While running if you ignore the fact that in the beginning of a run it always locks to the cadence (always been the case since Spartan) it usually is much closer to AW or strap (then again I never run without a strap but did a couple of easy runs to test).

better to have this date than this one : 31.12.1989

I used the mermaiding mode for the first time today and the dive screen didn’t show any live data. Is that the problem referred to here or is there a different fault with my watch? I’ve tried to recreate it as a custom mode but it doesn’t look like that’s possible.

@isazi said in outdoor watch face: but I can see the baro tred being available as a graph/complication when watch face customization will be implemented.

@Mff73 agree, nothing to do with GPS, most certainly environmental: snow blocking the baro sensor, strong wind, gloves or other barrier blocking the baro sensor, etc. I did many mountaineering activities in the Alps with S9P and S9PP without this happening, so it is not because of the sport mode.

@Lukas-Krempasky which is even more frustrating as titanium version is more expensive

I’m assuming the status is as listed in the other thread here? https://forum.suunto.com/post/104721 Went out for the first swim in a pool. Beta Android app didn’t show distance. I used the swim interval S+ app which actually showed (double the actual) distance swum under the laps/interval section. That double distance was passed on to Strava also. My stroke was generally consistent each length but I’m not a great swimmer so I can understand why it would double it.

@vincent-mayousse let’s hope it will.

@Andersson This has happened to me as well, I do not know what is causing the problem. If it is repeatable we can send logs to Suunto. What @Likarnik said worked for me as well.

@Felttie try what @Mff73 said. Did you try reinstalling the app too? If none of those work a hard reset is likely necessary. I see you did reinstall. Soft or hard reset on the watch.

@Mff73 I wondered about it, but since it never happened during the activities I thought it was not possible. glad to know it works!

@joaojesus Just curious…why do you want that?

@isazi reproducible after a factory rest, as per support’s suggestions. Thanks! Happy to send logs.

@Elipsus said in Suunto 9 peak pro now with continuous HRM ?: I noticed since the last update on my 9PP that the HR sensor is now always “on”. yep!

@zhang965 Thank you.