@false said in Problem with the number of training hours: same here https://forum.suunto.com/topic/9859/software-update-2-30-32/122 https://forum.suunto.com/topic/9859/software-update-2-30-32/220 I think there is no work around and we only have to wait for software fix Thanks for the feedback!

@rooldaa I do not know if it shows in the widget but should show in the Weather S+. I will ask Suunto about this.

@enriqueescoms said in Warning in structured workouts?: @taziden Oupsss. Thank you for your reply. I didn’t know if I was too clumsy or if it wasn’t possible. Well, I hope that in the future it will be possible to implement. I think it is quite useful. I hope so too, it’s much needed.

@kamarasm hey i know that in Xiaomi Smartphones there are big Problems connecting a WHOOP device. This is perhaps a Bluetooth Problem with Android 13 and Xiaomis MIUI 14. had a WHOOP device cause of the HRV measurement. And it didnt Connect with Bluetooth and my Phone. There we have to wait for Android 14 the support syas me. I only can saye thise foremy Xiaomi device with WHOOP. Could it be that this could be a Android 13 Problem in combination with MIUI?! If this is probably here your Problem i dont know. Did you try to pair with another phone?

@Egika Was that a rhetorical question?

@vjakub the calibration itself is not influenced. Just under the jacket there is a high probability that during movement air pressure building up periodically inside of the jacket. Thus generating noise in the barometric sensor signal.

@enriqueescoms looks like the advent of HRV has changed this https://forum.suunto.com/post/129322

@Egika ok, thanks a bunch!

@Egika said in Mountaineering mode indicators: @adambentolila here are most of them: https://www.suunto.com/Support/Product-support/suunto_spartan_sport_wrist_hr_baro/suunto_spartan_sport_wrist_hr_baro/getting-started/icons/ But that is only a partial list and quite old……

@Dimitrios-Kanellopoulos Indeed yes, so that means it should check whether it sees a pulse or not. My problem is that i’m using a loop strap, so I can’t rally put it in a way to stop the OHR, but that’s really minor trouble (especially because i practically never remove my watch)

@tiago Surprised by your post I went to check my watch and you’re right, there’s a bug from my point of view too. On the Race, it’s possible in Trail interface (Pace/Power/HR) but impossible for “Running” where Intensity Zone options are for Pace / HR only.

Had found that, too.

@MRobertson it was most likely not updated by the technical writers

@alfredzhong What matters to me is GPS tracking time, I don’t care if I have to charge once a week or every other week. I did a recent 100 mile (162k) ultra with the 9PP and at 34h (yes I was slow) I still had battery life left. I used the watch on Performance mode with a route loaded. Quite happy with that. This was on a pre-release version of the firmware that will be coming.

@Mff73 you would loose altitude accuracy. Reaching down to 20m under water results in 1bar additional pressure. 1bar=1000hpa Around sea level 1hpa=8m of altitude. So the factor of pressure change above and below sea level is 1:8000 Cannot figure out the rest of the math, but altitude would jump in like big steps and not the 1m we are used to.