[WATCH] Battery drain out quickly

[SlaSh]

@frédéric-fiandino don’t see any problem, looks like my Baro battery usage. You charge your watch via usb?

[babychai]

Hi,

I have 2 problems here.

When i connect the watch via Suuntolink and upload a new move, the battery automatically drops a lot in my Spartan Trainer Wrist.

Another problem is my watch when charging it will never reach 100% fully charge. It will stuck at 99%. When i disconnect the cable and re-connect it back again it will drop to 95% from 99%.

Please advise. My watch and Suuntolink are latest version.

[sartoric]

@babychai
Did you already try to reboot the watch ?

[Mff73]

@babychai
How long do you wait at 99%?
Long enough?

[babychai]

@sartoric yes i reboot once but problem still same.

[babychai]

@mff73 99% stuck at about 45 mins. i think last time can reach from 99% to 100% within 15 mins before the app update.

[Dimitrios Kanellopoulos]

@babychai Ok.

Batteries should never reach 100% or overcharge no matter how long you have it to charge it will always stop at 99%.

Trainers have less accurate batteries than the other Spartans. They measure on less precision.

I would not worry neither leave my watch plugged in when it’s 100% nor would I empty it.

Change full and deplete the battery 1nce per month

[Shrek3k]

Apologies, but my SSWHR definitely charged up to 100% without any issues and more or less “steadily”. I saw 95%, left the watch for probably 15 more minutes, and there were 100% (used a USB-port from my PC … as I usually just let it “hang” after synchronizing the activities to MC).

[SlaSh]

@shrek3k WHR version is having different battery which calibration profile is more accurate. Do not compare with trainer.

Anyway everyone needs to do full battery cycle (full charge/discharge/charge) time from time to calibrate the battery, this will improve battery percentage information accuracy.

[Gabriel.S]

hello, i have done a full charge/discharge/charge cycle and the problem still continue. i lost 20% in 24h, and 40% during a 2h40 run.
I will try to downgrade the firmware to the v1.12.36 to see if the issue continue or not.

[sartoric]

@gabriel-s
well … do you have 24/7 HR and sleep enabled ?
20% in 24h doesn’t look so bad. It’s less then 1% per hour.
Watch-face ?

[Gabriel.S]

Yes i have 24/24 HR enabled and the night i put the watch in DND mode.
The watch face is the outdoor like i have before the update, with the 1.12.36 version the watch loose 10/12% per day.

[sartoric]

@gabriel-s
Maybe you can try changing watch face before downgrade.
I always had the suspicion that the “outdoor” one is a bit “energy consuming”

[babychai]

@slash Got any fastest way to discharge the battery? Kinda slow if i just let it deplete by itself

[Dimitrios Kanellopoulos]

@babychai open GPS

[babychai]

@dimitrios-kanellopoulos Haha…noted, thanks

[sartoric]

@babychai
… and turn light on

[JohnH]

@frédéric-fiandino Got the same issue after update, it only charges to 99%. I did only chrage after it was completely dead 0%

[Frédéric Fiandino]

@johnh after one full cycle of discharge/charge/discharge, the problem seem as though resolute

[Dimitrios Kanellopoulos]

@johnh I would not worry at all about the 99% as said before it stops to get 100%