Suunto Software update Q1 (2.53.42)

brave_dave

@aiv4r
Thanks a lot. Did not know that you can observe trends. Where can I find it? Was looking for some explanation how to use this function but couldn’t find any official explanation. But yes, if you can observe trends and you stick with always the same protocol than one can use it. So is then the feedback “normal” also based on your individual trend? Because if Suunto defined what is normal then this might not be accurate if you deviated from their defined protocol.

brave_dave

@EzioAuditore
There are scientific studies that show that there are actually big differences between standing vs. sitting vs. laying down. So therefore it is quite important how the rest period is performed.

aiv4r

@brave_dave That is how I understand it based on this video by Suunto: https://www.youtube.com/watch?v=Jh0gD05DngU it starts on topic at around 5min mark.

EzioAuditore

@brave_dave Surely there are. That’s why I stated how I porefer it and feel it. I am much more ‘calm’ when after high intensity I slow rather than stop and feel/listen to my heart beat

Manuel Extreme

@Miroslava Treadmills are usually only compatible with Polar chest heart rate straps (not optical armband sensors).

Miroslava

Thanks i didnt know that because i use a biceps belt from Coros

gkaempfer

@Danny-poleg If you happen to be referring to the Vector Classic watch face then indeed it has a battery drain issue (at least with the previous firmware). See https://forum.suunto.com/post/187506. I have a V2 running the latest firmware without battery issues. Just make sure that you have wireless network and wireless discovery turned off (as long as you don’t need to update maps or connect new BT devices). I use the Athletics watch face. It managed <5% per day (24h) without activities.

Sebastian Wagner 0

@Miroslava
The hr broadcast to a treadmill has Little to do with the Brand of the hr Belt. And more with connectivity Option of the treadmill. So for example my treadmill at Home can only Display via Ant+ . If you have a hr belt (no matter the Brand ) that has the possibilty to send Data via Ant+ the hr Data will transmitted to the treadmill and you can see it on the treadmill display. The hr broadcasting from the Suunto Watch is via Bluetooth. So the treadmill Must have the option to receive hr data via Bluetooth, if that is not the case you can‘t get the hr Data broadcasted.

Egika

@gkaempfer said in Suunto Software update Q1 (2.53.42):
Just make sure that you have wireless network and wireless discovery turned off (as long as you don’t need to update maps or connect new BT devices). I use the Athletics watch face. It managed <5% per day (24h) without activities.

If you switch off Wifi in the watch, it will not update weather and A-GPS data overnight, when the known Wifi is within reach…

Miroslava

@Sebastian-Wagner-0 ok thanks i dont know which systems on the treadmill is. I was at thr gym. Ant or bluetooth.but nevermind