Zonesense readings
-
@duffman19 I scrolled down on the link you gave me - and saw that they were getting the same problem even if they used a Suunto HR belt. Looks like a Suunto Run is the watch - probably the same software as my Race S but I’ve not had any poorly synced data like they are getting. Yes - sometimes I see “Synching HR data” on my watch when using my Polar H10+ belt. My H10+ belt data is spot on and logged correctly in the phone app every time.
1 the ZoneSense real time counter was freezing (apparently fixed with last watch firmware update - but I’ve only done short fast workouts since so haven’t tested it properly yet)
2 If I push hard on my workouts - near VO2max - I never get an upload of ZS data on my phone app.
3 the watch logbook HR graph is just totally wrong - but seems not to be interfered with by ZS !I’ve deselected ZoneSense from both running and walking.
-
@MKPotts I’m not getting “bad data” - it plots correctly in the phone app. There’s a problem with the watch logbook graph display.
As for checking the HRV in Runalyze I’m assuming it would need to be taking it from ZS data - but the watch practically never uploads the ZS data - that’s one of the other problems. I uploaded a fit file from the phone app to look at on Runalyze but it had no HRV data. If the HRV data is just extracted from the raw H10+ belt input then I’m just not seeing how to access it.
-
@Ian-Beveridge Post the R-R data graph from Runalyze as @MKPotts did. I would bet yours is very bad. If poor, this is why your ZS data is not parsed to the app. From the HR traces on your watch something looks off. Just saw your last post, if no R-R data is in Runalyze then there is clearly something wrong with the belt and not the watch. Are you using the Suunto Run. Here is an image from my last exercise using the Suunto Smartsensor belt with Suunto Run. I was doing an interval workout 4x3 min hard so I expected my AT to be off, LT was good.
