Watch zonesense data field
-
@BastMaSVSRS9PP I have not seen this, it could be bad HR strap data or battery in HR strap is starting to fail.
-
Thanks Brad. It shows up correctly in the app. It’s the live measurements on the watch which do this …
-
@BastMaSVSRS9PP Reinstall ZS and perhaps try a soft reset on the watch. What belt are you using?
-
@Brad_Olwin
Will do. It’s actually a brand new Suunto one -
@BastMaSVSRS9PP said in Watch zonesense data field:
@Brad_Olwin
Will do. It’s actually a brand new Suunto oneMake sure the belt is wet when you start and does not dry out. I would check the battery. You can do this on the phone with an app or on the iPhone SA app when paired.
-
@Brad_Olwin
Sounds good I’ll report back in a couple days -
OK so I ran this morning Issue persists.
I did wet the heart rate belt actually soaked it. I also reinstalled the ZoneSense app. I actually noticed the zonesense summary does not show in my app on my phone either. It’s very odd.I will now go to the next step and replace the battery and try it again. If that doesn’t work I’ll try with my vertical and see if that gives any other result.
-
-
This is how it looks like middle of my run. ZoneSense stopped accumulating time in each zone
-
@BastMaSVSRS9PP I assume you tried a watch soft reset? And you are running the latest firmware? If you examine the R-R data in Runalyze it will show whether the data are poor or not. I assume you get HR the entire time?
-
@Brad_Olwin
Yes soft reset , uninstalled and reinstalled the zonesense app. Heart rate looks good otherwise. Continuous , no breaks
