9 BARO To Elite turbo muin smart +
-
Hello sirs how are you, I have a bike trainer Elite turbo muin smart + ,it has a Bluetooth and ANT+
Connectivity sensor both speed- cadence and power sensor,my problem is that ,
I can not connect and configurate the powerpod when I am going to start an indoor activity .
When i go to settings and make a bikepod and power pod confirmation I can do it ,but when I am at the activity,
At the screen Its only active the bikepod and the powerpod is not .
I see on the field screen only speed and distance active but not cadence and power,I try to do power pod calibration and it can not find the sensor just a little while before it had made a connection.
Do you have a suggestion for this issue?
Is Suunto support these type of sensors?
Any thoughts?
Thank you -
Hello, @georgekostaras,
I do not know that trainer. Anyway, I think that you are trying to pair the same trainer twice. Once as a bike pod and then again as a power pod, right?
If so, then it’s not correct way.
Pair the trainer as a power pod only. In the activity settings, enable Power POD only. not the Bike POD.
During activity itself, you should receive all relevant informations, like power and cadence, as it is very likely that smart trainer transmits both of these informations via Power POD.hope that it helps you.
-
@zadow thank you,I will check it,
Regards -
@georgekostaras I have direto x and I don’t get cadence value via power pod connection, only power data.
-
@Likarnik , hm, I have TacX Flux S 2, and I get both, power and cadence. Thru the virtual training apps, I am getting speed as well.
Well, on the other side, the truth is, that I have never paired trainer directly to my watch. I have paired it with virtual training app (Fulgaz), where all these data are displayed. -
@zadow yes, sorry, I meant on watch, pairing it to Zwift/Rouvy I get all data from trainer (powered, cadence, speed).
