S9 peak stuck on "the device is being restored to a safe state"

[Mff73]

@Danny-Labrana
This issue is not so known/common issue. It is more a generic message that watch has tried to repair itself but finally is not managing to do it.
It could be well a real hardware problem, maybe (or not) emphasised or revealed by this software update.
Thus the answer of support, if HW issue, only tech team could check, and if warranty is over, it is just the common unfortunate situatio’/timing.
But, hey, just speculation.
Is your watch completely blocked or can you access it in the app sometimes?

[addib]

@Mff73 it will boot briefly about every hour display error code 1403. But then crash again after about 10 seconds and go back the the repair screen. So nothing really that I can do while it’s up.

[Danny Labrana]

@Mff73 Thanks for the update. Regarding the watch: completely unusable.

[MKPotts]

@Danny-Labrana
Which watch do you have? You’ve posted against a 9 Peak topic and mentioned the problem happened after a software update - but the 9 Peak hasn’t been updated for at least 2 years.
If the 9 Peak Pro, I don’t think the Q3 update is available yet (at least it isn’t for mine), was it the June update that caused the problem?