"Power saver tilt "... not working after a while
I’m new within the Suunto Community and happy with my brandnew Suunto 7
there is one a bit annoying thing:
I set the energy option like mentioned in the manual:
- Keep Power saver tilt on
- Keep Tilt-to-wake off
- Keep Always-on screen turned off
Mostly everything is fine but after a while turning my wrist won’t show the low-power version of the used “Heatmaps watch face”. The display stays dark. The only way to activate something is touching the Display several times…
Is that a normal behavior or is that something to investigate ??
Thanks in advance!!
@kasperle Try a soft reboot and see if that helps. Long press upper left button for 12s until the watch restarts.
@kasperle My experience with the power saver tilt simply brightens the low power display a little when you tilt the watch up to look at it (useful when outside but less so inside I find). It will not show any extra information such as the heatmap etc.
I currently have the power saver tilt disabled as it can interfere with following a route when tracking an activity.
@kasperle I have the exact same issue with the suunto watchface and the others.
@Brad_Olwin I’ll try that… maybe there’s a connection between the reported behavior and notifications… I continue to observe this issue and report again
this is a known bug I think.
What happens is this.
You change the settings to what you want A. -> All work ok.
then you open Suunto app on the watch and the Suunto app remembers that setting
You change the setting to something else B
You open suunto app and once you close it it restores setting A instead of B
To over come this you need to reboot the watch as it wipes out the setting that Suunto app remembers and sets back every time you open / close it