Suunto Software update Q1 (2.53.42)
-
@EzioAuditore ha. Well I could’ve sworn it wasn’t there earlier. But now it is. I must’ve been mistaken. Thank you.
-
@tomtom73: same here.
For example, my watch went from ~18% to 0 over night tonight while I was not wearing it. Battery consumption is also higher while normally wearing the watch as well as during activities since the update. I have rebooted the watch several times since the update.
I’ll observe battery consumption a little longer still, to possibly identify a pattern, but as several other users have reported the same here, I think that it would make sense to look into the issue a little bit further from Suunto side (@dimitrios-kanellopoulos).
-
Hi,
Since updating to 2.53.42 my maps are completely black on my Race 2, all regions (I tested it in Taiwan, Hong Kong and Switzerland). GPS works fine, my position is tracked correctly, and if I load a route it displays as a blue line on the black background, but no map tiles render at all.
Steps I’ve already tried:
- Deleted and re-downloaded all map regions from scratch (after the firmware update)
- Restarted the watch
This was working fine before. Has anyone else seen this after 2.53.42?
Any help appreciated.
-
@Hugues-Vinzant
Did you check that map style is not “off” on your watch? You can setup light map/high contrast /off. -
@Hugues-Vinzant I have a Race S and had a hike today and played with battery management. Only in performance mode the map was visible, in all other modes black. Perhaps you set a different battery mode?
-
Is there any more info if the vertical 1 will get any update? What I have read this was not sure.
-
@helgonet12 should arrive but no date
-
@Tieutieu thanks for the answer
but the question was if there will be any. Since what I have read this was not clear. But maybe you know for sure 
-
@helgonet12 as of today it is not sure, what changes can still fit into V1
-
@Egika thanks for the info
-
@helgonet12 not sure, so I guess I should had wrote « may/could arrive » instead of « should »
