2 problems with Suunto Vertical at once : Buttons and screen

fondueaufromage

Dear All,

I have for the first time a serious quality problem with my Suunto Vertical watch… not just 1 but 2 problems at the same time. Obviously, this appears 2.5 months after the end of the 2-year warranty.

It seems my watch didn’t survive my last 8-minute swim because the next day, I wanted to use it and I noticed two problems :

Pressing the “up” button performs the actions “up” and then “confirm” (SV_up.mp4 ). Pressing the “confirm” button performs the actions “up” and then “confirm” (SV_confirm.mp4 ). I tried a software reset as well as a hard reset but it did not solve the problem.
Three air bubbles have appeared under the glass. It looks like it’s starting to come unglued.

The bubbles aren’t a problem for use, but they’re visually unappealing. On the other hand, the button issue is very annoying to navigate the menus.

Has anyone else encountered either of these problems? I seem to recall seeing a post on the forum where someone shared a photo of the bubbles, but I haven’t been able to find it.

Thank you for reading.

cosme.costa

@fondueaufromage

For the problem #1, have you tried a soft reset? 12/15 s upper button?
For #2 aren’t you using a screen protector?

fondueaufromage

@cosme.costa
For #1 : Yes, I did a soft reset and also a hard reset.
For #2 : No, I don’t have a screen protector. The bubbles are under the glass, on the crown where the minute markers are.

Mff73

@fondueaufromage
For the buttons, you might try to clean them (like put watch in gentle warm water, with few soap and brush gently). Maybe not the pb, but worth trying.
After, if soft or hard reset didn’t change anything, it is looking like an internal issue. Is it doing the same for all menus?

Egika

Also thought there probably was a protective film in place.
But if you have button + screen issues, I would definitely send it in to Suunto.
Their technical service is top notch!