Software Update 2.48.16 (2025 November Rain release)

[Kaiphi]

Update has been successfully installed on the Vertical 1. I think even without loss of a personalized sport mode. Sleep report when waking up in the new design. If I open it again, it will be in the old one. Had no battery problems before and not now. Just 2 hours on the bike with 1.3% per hour consumption with best gps.

[Josaiplu]

I’m currently get phantom vibration on my race 2, only suunto belt paired (fresh post update)
Watch vibrate without nothing displayed at all post activity
If I open the activity pre start page I see the belt already connected
I will soft reset and it will disappear but bug still here
The disconnect issue I suffer last time was gone after doing unpair/pair of the belt
I assume that battery drain can be caused by such behavior if the watch continue to look for BT devices after an exercice it is quite energy consuming

[Stefan Kersting]

@Josaiplu I had the same problem too and reported it. But nothing was done with it. Think too that it’s part of the battery drain problem

[Dimitrios Kanellopoulos]

@Stefan-Kersting afaik it wasn’t

[Dimitrios Kanellopoulos]

@Josaiplu is the sensor on the belt ?