Software Update 2.44.46 (2025 Q3)
-
@SergioB thanks for this info. In my case it was out of an activity. I was sitting in my car, listening to relaxed music, was not even driving and the race showed a heart rate of 142. After the shift reset it showed a 62. Strange…
-
@rooldaa said in Software Update 2.44.46 (2025 Q3):
I think I’ve found a bug.
After the update my pulse zones have been changed so I changed them back to correct ones.
But after today’s run the app shows wrong values - the ones that appeared on the watch after the update.
The watch still has the correct values.
Yes, I can confirm this. Watch an app are not in sync.
-
S sartoric referenced this topic
-
I think there is a bug with receiving HR from a Polar H10 chest belt when Wahoo Speedplay Powerlink Pedals are used. After the update to 2.44.46, my Vertical will not display or record HR from the H10 when the pedals are connected, but will work as expected when the pedals are disconnected -or- if I switch to a Suunto SmartHeart HRM.
Does anyone else have this setup or can add insight?
-
Unfortunately, the erratic behaviour w/r to Stryd power recording persists with this update.
I did three runs so far with the the new firmware. The first two runs showed the correct wattage (Stryd) on the watch and the correct wattage was written to the fit files.
Now the third run does not show the Stryd wattage but probably the Race S wattage. Furthermore, Stryd wattage is not recorded in the Race S fit file. This is the same behaviour as with the previous firmware version.
Below the Stryd fit file wattage (red) vs the Race S recorded fit file wattage.
I will revert back to the last working firmware. Bummer.
-
@safari I had a similar experience but I had the watch on the carger but it sucked the battery still empty and took for one map around 1,5 Hour
