Suunto 9 Baro crashes into firmware update mode
-
During training, it stopped on its own. I tried to restart the training several times, but the watch couldn’t find GPS for a long time (20-25 minutes), the screen went blank, and the training was interrupted (it returned to the main screen of the watch). Then the watch caught GPS and the training started normally. I ran 5 km and stopped the workout as usual. It synced with my phone. Then the watch automatically switched to firmware update mode (down arrow with 4 dots). I connected the watch to my computer and launched SuuntoLink. The app told me that I needed to reset the device, I confirmed the reset, and after a while, the watch reset and asked for settings (as after purchase). I made some settings (dial, heart rate zones). Then I connected the watch to the mobile app, and synchronization began (routes, interval training, etc.). I left the watch and after a while saw that it was back in “firmware update mode.” When I connected to SuuntoLink, a message appeared again saying that I needed to reset the device, but now no matter what firmware I tried, the process ended in failure and the watch did not exit “firmware update mode.”
Is there anything that can be done about this?Suunto 9 Baro
-
@Dr1mo seems like a hardware failure
-
@Dr1mo Does it make sense to write to support? Are they repairing these models now? The warranty has already expired…
-
@Dr1mo you can always try and see what they say
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login