Spartan FW 2.0.42 Target and Logbook bug ?
Last night I had a short jog of 30 minutes with a target programmed on the watch not to exceed the zone 1 FC (<130bpm).
I run with a smart sensor belt.
After a few minutes I have a HR peak of a few seconds at 174bpm, well beyond zone 1. The watch warns me that I exceeded my target, I rule the problem of the belt, the frequency decreases . But I spent at least 1 min outside of zone 1.
At the end when I stopped the activity, on the screen of the report, at the level of the distribution of the HR, the watch tells me 100% of the time in zone 1.
But when I went back to the logbook, the distribution was good.
To be confirmed by other but maybe there is a little bug in the firmware 2.0.42
PS: Workout -> end of workout screen -(bug) -> watchface time -> logbook (no bug)
@Frédéric-Fiandino they are filtered on post processing
Its ibi data BTW.