Suunto ZoneSense

SamuelP

@timecode it happened me the first time a few weeks ago. I didnt wet the belt before my run. I guess the connection was good enough for HR but not the r-r data. After a while probably my sweat made the connection better or something?

isazi

@SamuelP indeed, if the data is too noisy it is not used for ZoneSense, data needs to be quite clean to be used.

timecode

@SamuelP good hint, thanks. I will try it again tomorrow and keep this in mind.

SamuelP

@isazi would be nice if suunto app could tell the quality of the data(like runalyze), would help with all the confusion

Brad_Olwin

@timecode If the HR belt dries and/or you have a tech shirt and dry belt it can cause problems. I thoroughly wet my belt before I run and I typically sweat enough that the belt stays wet. If you stop and dry out it could also be an issue.

timecode

@Brad_Olwin thanks. I also always wet the belt and sweat a lot, like A LOT. But it of course can happen that it dries out - today was quite cold, so it’s possible. I’ll try again tomorrow.

Brad_Olwin

@timecode said in Suunto ZoneSense:

@Brad_Olwin thanks. I also always wet the belt and sweat a lot, like A LOT. But it of course can happen that it dries out - today was quite cold, so it’s possible. I’ll try again tomorrow.

I rarely have loss of data from ZS but it has occurred. The last time this happened my belt battery was about done. I finally remembered to check it.