i continue having problems with the altimeter items
-
gracias @Mff73 , its the version without baro, only suunto 9… i send mails to the suunto support, but they dont help me with a solution…the other suunto i had, spartan, i had problems too, and i send to finlandia, and the gps rreturns with the same fail…i dont know what i have to do
-
@Carles-Merin
alright, forget about my post…
GPS altitude is always less precise than with baro. -
yes, correct, but my friends have ambit 3, and the precision was perfect…i dont know how explain this
-
@Carles-Merin
Ambit 3 what? Run? Sport? Peak?
EDIT: …sorry, you mentioned it…
maybe it’s because of a different GPS chipset… but there are people here knowing that better than me!
I thought I give my input on that question that was related to pressure sensor is measuring “pumping on skin”… -
@TELE-HO its the version without baro, thanks
-
@TELE-HO one ambit sport, and 2 ambit run,
-
Try to reset GPS - see https://www.suunto.com/Support/Product-support/suunto_ambit2_s/suunto_ambit2_s/adjusting-settings/service-menu/ (this should be the same for A3 too).
-
it a suunto 9. i made a factory reset a few months ago with moveslink
-
@Carles-Merin The Garmin5 series have barometers. Without a barometer the GPS altitude is just not that accurate. On larger climbs it seems to do better but not on small ones. The S9 without a barometer will not record an altitude change unless it is over 7m. If the altitude is important to you, the S9 with a barometer is a much better choice.
-
ok thanks. i know this, with barometer is more exact, but other suuntos like ambit run and ambit sport 3, give the correct values, and my suunto, that is more actual, give an incorrect values of altimeter
-
@Carles-Merin Make sure the AGPS file is current so always sync the watch with SA before you go. I do think there is room for improvement with the altitude in GPS. The antenna on the Ambits is outside the watch and the chipsets are different but you should not be that far off. Have you used Dimitrios’ QS site to see where the differences are? In addition, do you have the latest firmware?
-
@Brad_Olwin yes i have the last firmware, and i sincronise the watch until go to run, but the values dont be correct.i find satelits, and i wait 2 o 3 minutes to have a better signal, but dont works well…sometimes, i start the move, and i m running downhill, and the suunto is increasing the meters of climb up!!! how can be this ??
i really very bored with this watch…it have a good estetique, but the software give me a lot of problems… -
@Carles-Merin ill create an issue for this.
-
@Dimitrios-Kanellopoulos thanks.