Updates for V1

[cosme.costa]

@plopes73 I have read somewhere, I do not remember where, that there is a bug in the widget that do not shows the real solar harvesting, but it works correctly. This bug has not been adressed yet, could be this?

[sartoric]

@cosme.costa
there is a refresh bug in the history widget, but the real time view shows the current state correctly
Mine goes from idle to maximum… depending on the sun ofc
in these days, almost always at maximum

[plopes73]

@cosme.costa Could be, I’ve not notice differences in battery, but then again, solar harvesting do not charges battery, only helps a bit. However my widget only show idle and minimum (a very small colored dot in the middle of the scale). Also the 15min bars are always on minimum, on these clear days they were at least half way after some runs. Hope that is true, only a bug in widget Cheers

[plopes73]

@isazi On mine, the wiget doesn’t work as before and as far as I read, in the last firmware update solar harvesting was not in scope, but in my watch it’s not the same, at least what’s visible on the widget. I have never had an issue with any update, not even some reported issues with battery and all that That’s why I found this strange ;). Cheers

[plopes73]

@sartoric On my watch not even the live widget (on the watch face) shows more than minimum, just idle and minimum, even on direct sunlight. Maybe I need to do a hard reset (the one with 60 seconds on the charger), soft resets didn’t work. Thank you for sharing that info. Cheers.

[isazi]

@plopes73 unfortunately you would not be the first to have some hardware issues with the solar harvesting module. If your watch is still under warranty, contact support to have it checked and possibly repaired.

[babychai]

@plopes73 do you using screen protector?

[LitchiMonster]

@plopes73 this happened to my watch, I sent it in. They checked the solar module, agreed it wasn’t working, and they replaced the watch. Unfortunately the original was made in Finland and the replacement watch made in China. Oh well, it works now.

[Egika]

@LitchiMonster said:

Unfortunately the original was made in Finland and the replacement watch made in China. Oh well, it works now.

So maybe this turns from unfortunately into fortunately

[plopes73]

@babychai No no, never used screen protector. Suunto saphire glass is very good, no need to protect it with a weaker layer IMO. But I think it’s a hardware issue, watch is not in warranty anymore, but I can live with it, until Suunto Vertical 3 release :). Cheers.