Software Update 2.44.46 (2025 Q3)

Dušan Ković

@isazi I just tried Zonesense intensity rings on a gravel ride. I think there is a bug.

first 9 minutes there was no rings, which was expected, as zonesense kicks in after about 10mins
after that only white arrow showed, there was no color rings.
at 25mins in activity I had a hill and I went onto an-aerobic zone, suddenly ZS zone 2 showed yellow
after the hill, it went back into ZS zone 1 and suddenly ring became green, so we have colors
during the ride I kept glancing into the rings and on multiple occasions white arrow went back to zone 1 but yellow ring (zone2) was highlighted

I am guessing that it is just buggy behaviour and devs should take a look at it more closely

VoiGAS

@Dušan-Ković The same happened to me - but only with a target zone activated. Without the colour change like expected for me

Dušan Ković

@VoiGAS I didn’t have target zones. I know when you use any target zone only that zone bar is highlighted

Stefano M64

after the update every time I put the watch on the charger I get a “Map downloaded successfully” notification, even if I wasn’t downloading anything? why? it’s only me?
This happens in both Race and Race S

orzechszek

Hi,
Does anybody know why in such case when HR zones are set and properly visible in results:

training is still recognized as Vo2max?

Squirrel

@orzechszek said in Software Update 2.44.46 (2025 Q3):

training is still recognized as Vo2max?

https://forum.suunto.com/topic/13517/how-comes-this-run-is-classified-in-suunto-app-as-anaerobic

SamuelP

@Stefano-M64 happened to me also yesterday… I had 10% and left it “charging” and after 2 hours when I wanted to go out for a run it said “map downloaded successfully” and the charge was still at 10%, so it didn’t even charge the watch after removing the “map download” screen with the middle button it started to charge. That’s a bit weird. I also didn’t have any maps in the download queue.
I’m using a Vertical.

Sportsfreund

@VoiGAS not in my iOS app. There only I can see the other modes but without values.

On the other hand I thought you can set this value in the different activity modes in the setting.

VoiGAS

@Stefano-M64 Me too. I think already three times where I got this Maps downloaded message

Jan Suchánek

@Stefano-M64 Mee too. Race.

Chris_Dx

@Theo-Lakerveld Thanks for the information, I will try to do the same. Let see if I have the same good results.

soisan

@Squirrel I admire your patience with some members in this forum…

dombo

today I realized, that probably by update my global HR zones were altered. specifically 3-4 and 4-5 zone borders. on top of this my crank based power meter needed arm length (this info is set in the sensor and was not requested before. arm length is important only for pedal based power meters…)