Firmware 3.19.16
-
@isazi the same thing happens to us
-
@isazi ZS only after the fact in SA for now.
-
@herlas yes
-
@isazi it’s good to see Suunto can add support for extra types of sensors.
-
After the update, the leg cadence is showing strangely. -
@Alpha-156.42 what exactly is strange here? The numbers seem to make sense on first glance.
-
@Egika I think spm is steps per minute, can you explain to me what spm in the image shows?
-
Recovery value is still not synced between watch and app… anyway a good update, keep it up
-
@ShinJCD Now it works fine for me. At first it seemed not, but after a while it synchronised.
-
@6iovanni said in Firmware 3.19.16:
@ShinJCD Now it works fine for me. At first it seemed not, but after a while it synchronised.
I still have different values
-
@Alpha-156.42 maybe I still don’t understand your question, because for me it is very clear.
rpm: how many steps (left foot to left foot) you did on average per minute (<- this has been the Suunto approach to steps in other models)
spm: how many steps (left foot to right foot) you did on average per minute.spm = 2x rpm. the maths seem to be correct.
-
- Pause/resume reminder
In my opinion, it is still a little sensitive
-
@brechtvb maybe Suunto will do the same for other watches too
-
@isazi Thanks for the update. Unfortunately, two things I would have liked to see in the update are not included.
- an option for “raise to wake up” - display only, not fully awake!
- global switch for sounds and vibrations off
-
@ShinJCD said in Firmware 3.19.16:
@6iovanni said in Firmware 3.19.16:
@ShinJCD Now it works fine for me. At first it seemed not, but after a while it synchronised.
I still have different values
I solved it with the restore.
Returning to the update, for me the option to reduce the minimum time for the display to turn off is still missing, since 5 seconds are already more than enough (the minimum that is now, that is 10 seconds, is definitely too much). Furthermore, I do not see anywhere the option to activate/deactivate automatic brightness (I understand that there is a display brightness sensor anyway).
-
-
@isazi said in Firmware 3.19.16:
Support for cycling power meters
Oh wow, that’s quite big, really makes the Run a proper watch for triathlon.
-
@danyel I wonder, is the suunto run compatible with a seperate cadence and speed meter?
Linking a garmin cadence and speed meter is not possible.
-
This afternoon’s run: same 1km route repeated 8 times (4 out and 4 back). The GPS position at the start is already completely off, the road is quite narrow (two cars can barely fit) so all the gap you see in the various passages is definitely too much. All this to say that, if it’s true that the chipset is the same as the higher models, either it isn’t or there’s some problem in the firmware here too.
-
@ShinJCD Uh! I’m assuming you waited for a GPS fix and synced your watch before the activity, right? You didn’t say: multiband?