Suunto Race S general discussion

Egika

@carabott said in Suunto Race S general discussion:

Been using the Race S for more than a week now and noticed the following scenarios where improvement is much appreciated:

Whenever I land on some screen which is not the home/default screen, I would need to go back manually. It would be great if it can automatically revert to the default screen after x amount of seconds. This only applies when not in sports mode.

it does so. I go into the logbook and just wait -> watch returns to watch face after one minute or so. What exactly do you mean?

I noticed whenever I’m holding something with my watch hand and not swinging my arm while on a walk, steps aren’t counted correctly. This is annoying.

I think this is physics. As the watch is worn on the arm, it can only guess that you are walking, by arm movement. If the arm is held still, there’s no way for the watch to know about your steps.

More configurable watch faces are needed with more complications
slots.

Coming

I also noticed that breaths per minute and current HRV aren’t measured for some reason. These were some interesting metrics on my previous watch.

HRV is a metric that currently is only measured during the night to check your recovery status. Respiration rate was a metric introduced with Ambit3. It is a value that can be read from the HRV. I am just not sure what it would be used for… What’s your interest on respiration rate based on?

Stefano M64

@Egika said in [Suunto Race S general discussion]

I think this is physics. As the watch is worn on the arm, it can only guess that you are walking, by arm movement. If the arm is held still, there’s no way for the watch to know about your steps.

smartphone apps count steps on the base of the accelerometer measurements even if the smartphone is kept in a pocket or in the backpack and does not swing at all, moreover I noticed that the steps are about half the correct value if I walk with hiking poles, the arms swing but the arc they do is smaller in this case, hopefully the algorithm could be improved to detect steps in different situations

carabott

@Egika thank you for your reply!

Most of my observations come from years of using a Garmin watch. So, apologies if my comparison is not fair or correct.

Regarding the timeout, I don’t think I’ve every waited 1 minute maybe that’s why. Will try it out.
Regarding the steps issue, not sure how Garmin managed, but it was accurate over there.
Regarding the respiration rate, it was an interesting metric to observe while running (controlled breathing and all) and after sleeping. Sleep apnea related symptoms was a thing I was trying to monitor.

EzioAuditore

@carabott

Regarding the timeout, I don’t think I’ve ever waited 1 minute maybe that’s why. Will try it out.

I believe it’s much less than a minute. For example if I go to the HR widget and rotate my watch away from me, it leaves in ~10sec. You can also swipe to the right (back) from every widget and go to the watchface or press the down button (back).

Regarding the steps issue, not sure how Garmin managed, but it was accurate over there.

I have FR965, AWU and Race and I find the Race to count ‘active’ steps. These are steps where I literally walk not just goof around the house with minor movement. The FR965 can be tricked to count steps by just moving your arm, the AWU too but you need more simulation of movement so it’s more accurate for me. But for me the Race is much closer to the real (active) steps I’d rather count than count everything as a step.

Regarding the respiration rate, it was an interesting metric to observe while running (controlled breathing and all) and after sleeping. Sleep apnea related symptoms was a thing I was trying to monitor.

Valid point.

Cheers.

suuntastic

@carabott same for me for vertical. vertical is my dream watch, but it is sooo annoying, when using timer much or achieving some more messages… Vibration is so hard and little noisy. That’s why I use daily unfortunately more often S9P and vertical more for sports (bought very recently). Hard vibrations should be configurable (daily and sports). Coros Apex 2 also gets subtile vibrations. Why not Suunto? Can’t be that there are only few persons that saying…

Bexs2247

Can I connect my strava app to my race s?

cosme.costa

@Bexs2247 said in Suunto Race S general discussion:

Can I connect my strava app to my race s?

Of course, in the SA app, your profile, and partner services

Only new activities will be uploaded to Strava, previous ones must be uploaded manualy

Gorm Breinholm

@wmichi How did it go with support? I just bought a Race S today and wondered if the crown was meant to be so tight - enough for me to go Googling it. Found it mentioned on Reddit as well as here. Same low screechy sound as if it is rubbing the case slightly.

Bexs2247

Thanks. Also, can I get what’s app msg notifications on there?

I seem to have text and phone calls but not what’s app

isazi

@Bexs2247 in the app (on Android) you can configure the apps you want notifications from.

wmichi

@Gorm-Breinholm I contacted support immediately after taking the watch out of the box. I waited maybe 1 minute in the queue and the contact was professional and friendly.

I told the guy, that I think that my watch is faulty, that I am not satisfied with my purchasement and I want to return it. They forwarded me to a website where I could create the return label without asking more questions. They already refunded the money.

The only problem was, that at this time, this website would not let me create the return label due to a technical issue. It worked 24 hours later.

This was the first time I returned/replaced a Suunto watch.

Bexs2247

@isazi I’ve got an Apple phone

Michal747

Hello everyone.
I enjoyed my Suunto Race S almost one week. In fourth day first time I seen on screen information “The device is being restored to a safe state” and after few minutes “Error 1403” then smartwatch reset all settings. Next day the same situation. Since yesterday this situation happening a few times per day, I can not using my smartwatch. Anybody got the same problem or any experience with this kind of situation?

isazi

@Bexs2247 for some reason not yet possible on iOS

isazi

@Michal747 contact support, your watch seems faulty

Steven Vanlancker

@isazi At least you got one … I tried the waiting list 5 times and always was I in reach of a computer to order when in stock, every time I missed.
I was looking foreward to the Rs and I wanted to try one but I totally lost interest in the way it takes too long to deliver so I bought a Garmin. I don’t get why you are releasing a product and you don’t have stock. I understand that can happen due to the succes of a product, but not 5 times in a row.

If buying a watch is like tickets for Adele, it’s ok for me.

Ze Stuart

@isazi Apple, being annoying. On the AW, you can select which apps, but on iOS, I believe the only option for a non-AW is to echo every notification on the Lock Screen, ignoring grouping or phone DND.

isazi

@Ze-Stuart I believe that was the case in the past, but I heard Garmin and Coros allow you to select apps for notifications also in iOS, so something may have changed.

isazi

@Steven-Vanlancker not sure why you’re addressing me, and not sure why your only message in this forum is this one.

Bexs2247

Any ideas how to change the weather from Fahrenheit to centigrade? I don’t do Fahrenheit