Sensors full of Bubbles, Plastic peels off.
-
@GiPFELKiND this is not per SE Suunto hq issue. The issue is with Prague service center. Please contact them.
-
Just sent my watch to CZ, wish me luck on the delays ^^
On a side note, the DHL pickup at home is absolutely great, it feels nice to have things like that made to help you reduce the inconvenience, they grabbed my watch a 2 pm yesterday, and is already out for delivery in Prague -
@Elipsus I had my vertical replaced in a week roughly. Of course I am away from home for a month to test it and enjoy it On a side note though, mine went strait to Finland (no CZ in between).
-
@Hristijan-Petreski Good to know ! My guess is that the repair center in CZ is not yet trained on repairing the Vertical ? otherwise if my watch then has to go Finland from CZ instead of France that’s a huge waste of time/money/CO2
-
@Hristijan-Petreski said in Sensors full of Bubbles, Plastic peels off.:
@Elipsus I had my vertical replaced in a week roughly. Of course I am away from home for a month to test it and enjoy it On a side note though, mine went strait to Finland (no CZ in between).
Why you sent the watch to repair?!
-
@Elipsus said in Sensors full of Bubbles, Plastic peels off.:
@Hristijan-Petreski Good to know ! My guess is that the repair center in CZ is not yet trained on repairing the Vertical ? otherwise if my watch then has to go Finland from CZ instead of France that’s a huge waste of time/money/CO2
Why you sent the watch to repair?
-
@GiPFELKiND It was crashing every third run.
-
@Hristijan-Petreski said in Sensors full of Bubbles, Plastic peels off.:
@GiPFELKiND It was crashing every third run.
Hey my watch today Crash after 1,9km biking 🤮🤮🤮🤮🤮
Have you sent your watch back and get new one? -
@GiPFELKiND I was sending logs and contacted support. After the issue was not resolved with the Hard reset and soft I sent it back and was sent back another (I do not know if it is new or no since it is not new in a box but rather only the watch (without bands and original boxing since I was told not to send the bands and original box)).
-
@Hristijan-Petreski how long time until you had the “new” one at home? How much time did you wait until the “new” one arrived?
-
@GiPFELKiND As I Said the whole sending and receiving took a bit more than a week. Contacting support though took a lot but I was waiting for their response although I could just make a service claim. Once I made the claim the whole sending getting new was done in 8-9 days.
-
I had read this thread before and reminded again when I looked today at the sensor of the Sunnto 9 Peak Rro. It seems I got there bubbles too. They are still quite small, and are seen especially over the “AND” because of the phone in the reflection, but are everywhere, the white spots. I have bought the watch just last Friday. No sunscreen or hand lotion. Just water came in contact with it, and soap when washing hands.
-
@jannis that ist really incredible 🫣🫣🫣 i have same with Vertical. I sent it back to replace
-
are the first two numbers of the SN the year of production? two friends of mine have the same problem. mine starts with 22 and it’s ok. maybe a defective batch…
-
@gi0vanni @gi0vanni the first two numbers is the Produktion year, the next two numbers the week from the year.
-
@gi0vanni in the example above: production week 6 in Year 2023
-
Got mine back today. Sent in 12/07/23 . The backside of the watch together with the gaskets and screws were replaced. Hope it’s ok now. Couldn‘t check it cause I‘m at lake garda and my watch is in austria
-
What is actually the official stance from Suunto towards this? Are they denying this problem? It seems their 2 newest (and most expensive) watches, the 9 Peak Pro and the Vertical are affected by this quality failure.
-
@jannis what are they denying? If your watch is affected, it is a production defect and covered by warranty, you send it back and you get free repair or a new watch.
-
@jannis said in Sensors full of Bubbles, Plastic peels off.:
What is actually the official stance from Suunto towards this? Are they denying this problem? It seems their 2 newest (and most expensive) watches, the 9 Peak Pro and the Vertical are affected by this quality failure.
Just because you see a couple examples on the forum doesn’t mean it’s a quality issue.