Activity abortion
-
@jussim the watch getting into such issues during activity is quite unexpected though, if your watch is still under warranty I would contact support.
-
@isazi I did just that the last summer after this happened more than once. It was all kinds of useless endeavour, when all they had to offer was to advice to restore firmware to factory defaults.
Maybe I should contact them again about servicing, but I’d rather give the new firmware a chance. It’s just too much of a hassle to get the watch sent for inspection, not to mention being without it for a while.
-
@jussim I reported the issue with your logs to Suunto.
-
A couple of days after a fresh firmware upgrade, it happened again, 1,5 km into a run. Again I had Burner enabled. This time I didn’t have the down pointing arrow, only the watch face.
Great work Suunto!
-
@jussim
did you send logs again?
I did a couple of runs, no issue with the latest firmware -
@freeheeler Sure did!
-
@jussim your bug wasn’t fixed in the latest release, it is planned for a future one.
-
@isazi Wow, that’s a relief to hear. Kudos!
-
It happened once again and this time I had no SuuntoPlus functionality enabled. Can I keep sending debug logs or are the cause for this already identified and being worked on?
-
-
Last month, happened once to me: indoor cycling at 15 min, no app on, just cadence and HR belt sensors connected. No more for now.
-
Yesterday I turned on a new app on the same indoor cycling and it happened again, aborted with 2 minutes of action…
-
