Alarm during sleeping hours ?
- 
 @freeheeler hi ! 
 I set a sleeping hours of 23:30-07:05 and set an alarm for “once” at 06:30I have tones on the alarm but it didn’t ring . I was already awake though. This is the 3rd time I noticed . When the alarm is after the sleeping hours it is working fine 
- 
 @thanasis 
 I’ll set it up the same way and try to replicate. I’ll keep you posted
- 
 @thanasis my auto DnD is set between 23 and 8 every day, and every time I need the alarm is before that (otherwise I use my home alarm). Last time I used it is this morning, and it woke me up. 
- 
 @isazi I am resetting the figures as mentioned and I will replicate it I cannot understand if there is something wrong with it at my end but I really cannot figure this out 
- 
 @thanasis said in Alarm during sleeping hours ?: @isazi interesting … it’s not working in my case . Are you sure the alarm is set on a time within the sleeping hours ?? Mine is. Are you setting auto-DND or manually enabling DND? My sleep hours are set from 10pm to 6:30 am and this morning I set an alarm for 5:30 am.it worked fine. 
- 
 @thanasis I would set vibration too! The tones are not loud… 
- 
 @thanasis 
 good morning, just woke up by the alarm while auto DND was still active 
- 
 @freeheeler @Brad_Olwin @isazi thank you all I will reset my settings and try this again. Today it didn’t ring either 
- 
 Hello again, after resetting the watch’s settings , it worked. i still feel thought that there is something causing this instability, but since it is fixed I am happy with it  
- 
 @thanasis 
 please observe it and report immediately if it should happen again. You can then also contribute in sending logs.
 but let’s hope it’s solved   
- 
 Bringing back this topic … 
 Last night I left my S9p next to my bed with the alarm to ring at 06:59. The watch apparently went into sleep or something and the alarm rang when I picked it up at 07:51 (completely random time ) and not in timePlease note that I have disabled the HR readings and the DND and sleeping hours Does anyone have the same or it’s just my watch with that issue ? Thanks 
- 
 @thanasis I am reporting this and asking. 
- 
 @Dimitrios-Kanellopoulos thanks Dimitri 
- 
 @freeheeler a silly question: how do you enable “auto DnD” (as opposed to a “manual DnD” mode)? 
- 
 @MdzOtt it is in the sleep settings 
- 
 @thanasis could you please send logs if you can repro this ? I tried with no luck. Reported though and team asked for log s 
- 
 @Dimitrios-Kanellopoulos Sure! 
 i will try to reproduce it tonightI think the case is: - Disable HR & sleep tracking on the watch
- Leave the watch in location where it stays idle (should not get any movement to enter this “low power mode”).
- Leave your mobile without Bluetooth or out of range of the watch
- Set an alarm for “Once” in X hours
- Be patient  
 I will send the logs tomorrow morning 
- 
 @thanasis thank you very much 
- 
 @Dimitrios-Kanellopoulos said in Alarm during sleeping hours ?: @thanasis thank you very much I just Reproduced it as stated Logs sent just 2min ago 
 ThanksPs sent them 2 times , because the alarm rang after sending the first log set so I resent them right after again 
- 
 @thanasis thank you 
- 
 T thanasis referenced this topic on T thanasis referenced this topic on



