S9P crashing randomly
-
@jjpaz I think so (too lazy to check the code tho), but its a feature built into suunto watches, s.t. no matter what (i.e. battery dead/crash/etc) the activity is saved.
-
@jjpaz never a soft reset, but sometimes if I have to travel by airplane and carry many watches in my luggage I turn the watch off.
-
Today during the night my watch crashed (it was the second crash in about a year (first one was about half a year ago) , and when I woke up it said it has recovered…
The problem was, that it did not wake me, as alarm was removed…@isazi I sent logs at around 6:00 AM CET…
-
@isazi can you PM me on teams the TP?
-
@Ketoohs send me a PM with your username on SA.
-
@DF130 Latest update, managed a hard reset and reconfiguration, but that did not help either. Now I am just using the stock running mode, so far no issues (and not with any other sports, where I admittedly only use stock modes). So somewhere between custom modes (or the specific customisation I had chosen, “target” screen maybe?), S+, and a bunch of sensors (Suunto heart rate belt and Stryd), the conditions for a crash seem to develop…
-
@DF130 Last update, using stock mode was not a solution either, watch has crashed again today (when running as usual). Not quite sure what to do, maybe waiting for the next firmware update and hoping for the best…
-
@DF130 Did you see this: https://forum.suunto.com/post/115420
-
@el2thek No, not yet. Thanks for pointing out !
-
First time happened to me as well today, during bike exexrcise after 30minutes with HR belt on. However, the activity up to that point was saved. Logs have been submitted.
-
Same for me two days ago and I couldn’t synch the activity after the crash, the sync of the activity was endless. It was the first time.
-
@Kramble said in S9P crashing randomly:
Same for me two days ago and I couldn’t synch the activity after the crash, the sync of the activity was endless. It was the first time.
Time for vertical!
-
A new firmware should come soon, May or June.
-
I hope to update in near future also brings the S9PP interface to the S9P.
-
@cs2nd this won’t happen unfortunately. Was mentioned upon s9pp release.
-
New firmware worked quite well for my S9P - until today. Forgot to activate navigation after starting my activity (stock trail running), probably too excited as it was a race, but I should not have tried to use a route after that. Watch froze on the route selection screen and crashed after that. Seems that recording stopped some time during the freeze, maybe the last mile/km S+ is to blame as everything works perfectly when I try now. On the upside, the S9P survived my rolling breakfall down the mountain without a scratch