Software update 2.16.26 June 10th 2021
-
@dimitrios-kanellopoulos thanks for info. I am very excited to try snap to route. And at same time very disapointed that backlight toggle mode is away. Now on every button press there is backlight enabled even when enough ambient light. In average light conditions, visibility of screen with backlight on is even worst because it subjectively decrease screen contrast.
-
@tomas5
I use my watch with this backlight settings since day one I own it. And it really works for me
ā¦I even notice it better when thereās unwanted button press
-
@freeheeler yeah i believe that for many it is ok, or even great. For me it was first thing i changed on my old ambit and again first thing i changed on my suunto 5. Toggle mode was best for me. But if battery life will not be affected, than i donāt care. For now i was able to do some gps activity, keep 24/7 and bluetooth notifications and battery remained for 6-7days. In just 2-3 weeks i will see if this is just cosmetic issue or real issue for me
-
@tomas5
the battery life varied for me a lotā¦ the more I need to charge, the happier I am in general since it is a direct result of me doing way more what I love
living sideways
-
@freeheeler or battery deteriorationā¦
-
@tomas5 Prior to this firmware the standby backlight could be set to on or off. In the winter I would set this to on and it was continuously on 24/7 with a small effect on the battery. Now with the new firmware the standby backlight will be on intermittently so this should improve not reduce battery. The raise to wake does not activate the full backlight as does a button press but the standby backlight.
Vector/T6c/Ambit 3 Peak/S5 Copper/S3/S7 Ti/S9 baro Ti/S9P Ti/S9PP Ti/Vertical Ti/Race Ti/RaceS/Ocean/Wing
-
@Š“ŠøŠ¼Š°-Š¼ŠµŠ»ŃŠ½ŠøŃŠµŠ½ŠŗŠ¾
maybeā¦ but I donāt think so, it would be too soon now. I guess I can keep my watch until it effectively only lasts 12h with chest HR and performance modeā¦ thatās longer than I last with one dinner āchargeā -
@brad_olwin well in my case backlight was always off. Only enabled by toggle mode (Long press of upper left button). And usually it means it was enabled few seconds a day. Now it is enabled with every button press and received notification so it will be enabled not seconds but minutes a day since i use watch and notification regularly. Thats why i am worried about battery life, but as i said i will see in few weeks. Maybe it wil be unnoticable difference.
-
@freeheeler yes thats true, i am happy too when i move more often and do some bike or hike
but i must say that last year i am more lazy than i would like to be. 
But i am working on change. -
I think I found a backlight-related bug in my S9 (non-baro). Could someone try to replicate it?
My settings:
- Standby backlight: ON
- Raise to wake: ON
Choose any exercise and before you start it, set this up:
- Battery mode: Custom
- Display timeout: On
Start the exercise.
And now for that bug:
Once the display turns off, the button press wakes the display but it doesnāt turn on the backlight. Raise to wake also doesnāt work while the display is on. When you long press the middle button and enter the menu, backlight is still off. And even when you switch backlight to On in the menu it doesnāt work.Only in the moment when the watch shows āDisplay turning off. Press any button to turn back on.ā the backlight works as expected. If you press any button during this, it will work as it should (until the display turns back off again).
SV: fingers crossed :D
S9 (non-baro): died after 2 months, replaced, holding strong since 03/20
Spartan Trainer: casing broke after 23 months, repaired, lost watertightness 5 months later, died
Despite some pretty bad luck, I still love Suunto! -
@inkognito
confirmed with S9B -
@inkognito Iāll try and report it to Suunto.
-
Ghost runner is nice, Iāll use it for steady run that for me is the psychologically most difficult training.
-
@lorenzo12375 surprisingly enough I use it while hiking to see how fatigue impacts my speed over time.
-
Habemus Vo2max! Suunto5
Two workouts after update.
8km easy run
Custom running mode
Ghost+Snap to route+polar oh1
-
Hi that new watch face is quite useful. I miss only one information which is % of battery. Any chance to add it? That could be for example once backlight off.
-
@tomas5 It has (maybe just delayed a few days for S5) This function is really amazing when you run under trees or in the city . But it relies on open street map accuracy so maybe it will not be perfect for some outdoor trails
-
@mountaineerx
i miss my ambit 3.
more information on one screen. -
@safari
I donāt miss my ambit3 at all to be honest. I absolutely enjoyed it, but once I bought S9B and got used to it, I loved it even moreā¦ and I have 7 data fields without touching the watch
-
@inkognito said in Software update 2.16.26 June 10th 2021:
I think I found a backlight-related bug in my S9 (non-baro). Could someone try to replicate it?
And now for that bug:
Once the display turns off, the button press wakes the display but it doesnāt turn on the backlight. Raise to wake also doesnāt work while the display is on. When you long press the middle button and enter the menu, backlight is still off. And even when you switch backlight to On in the menu it doesnāt work.Only in the moment when the watch shows āDisplay turning off. Press any button to turn back on.ā the backlight works as expected. If you press any button during this, it will work as it should (until the display turns back off again).
Seeing this same behavior on my S9B now as wellā¦
