[Race - 2.53.42] Climb Guidance Segment Issue

SergioB

Hi, today I’ve encountered the bug shown in the photos below. I’ve created a route using Suunto App, beta version 6.12.6. The route can be downloaded here
The first segment, which was supposed to be a climb to be shown in red, was shown in gray, and it was not possible to zoom in. All other functions worked properly. All other segments worked as expected.

I was on standard trail running profile. I tried both without Suunto Plus app and with Suunto Plus App “Stifa”, but the behavior was the same.

EDIT: logs sent at 16:55 CET, linking this post

isazi

@SergioB I may try to report this because I have never seen it reported before, but 2.53.X is quite old (I know it is still the production firmware for the Race, but in development they are far ahead of this) so it may not be relevant anymore.

SergioB

@isazi thanks! This is the first time I’ve seen it too (and I use navigation very often)

sky-runner

@SergioB I have experienced exactly the same issue on my yesterday’s run - the first climb was shown as grey rather than red and zoomed in Climb Guidance didn’t work. I repeated the same route twice and had this issue both times.

And in general, I should add that Climb Guidance worked terribly and was wrong most of the time - repeatedly locking to the opposite direction at every single opportunity. It was frustrating!

Squirrel

@sky-runner Was this on your new Vertical 2?

sky-runner

@Squirrel Yes, Vertical 2. This was something that I’ve never seen before - the grey Climb Guidance segment. So perhaps a new version of Suunto App is to blame.

Edit: in fact I can still repro this by loading the same route: