Magene h603 pairing
-
Hello,I am a new user of a 9 peak pro and I want to pair with my magene h603 HR meter butt this is a no go🥺
Are there here persons with this combination?
Other with some pairing tips?
The magene works perfectly with my wahoo roam2.
Greetings from Belgium -
Make sure the h603 is not connected to the magene app before pairing it with the Suunto watch.
-
@pilleus thanks for your reaction, putt in new battery and the pairing went ok.
This app is not in use by me.
Now when I putt the 9PP on my handlebar and I view my
with te widget It says: busy with measuring but nothing on the screen.
going later this day on a walk with watch in pocket and the H603 on my chest. Hope that the device will record. Keep u posted.
Greetings from Belgium -
Just back from a walk and still no
recorded. Downloaded the magene app to verify my firmware and I am one the latest v1.20.
This app is also recording my.
Checked with my wahoo and immediately I have a puls.
Think my cheap device is beter than my expensive one
Greetings from Belgium -
@daniels770441 said in Magene h603 pairing:
Now when I putt the 9PP on my handlebar and I view my with te widget It says: busy with measuring but nothing on the screen.
You have to start an activity and activate in the section sensors your h603. Then you can see your hr during a bike ride or walk.
The widget is used by the hr sensor in the watch.
-
@daniels770441 make sure it is not paired with any other app or device. Go to the watch pairing menu and make sure you can pair it to the watch. If paired to the watch and turned on/active when you start an activity you should see the HR icon with a small block on either side. Has to be BT. Watch will not support ANT.
-
Hr sensor is connected and visible in the Suunto menu, itt picks up my
butt then nothing anymore. Did a walk with in the settings the HR sensor included butt no signal on the Suunto.
Installed the magene app and here works the device perfectly. Also on the wahoo.
Closed all the apps only Suunto and magene and no info on the display. Time to buy a Suunto heartbeat sensor a suppose
Greetings from Belgium -
@daniels770441 when you say “did a walk”. Did you start an activity?
Photos may help but as mentioned above the belt is only used during an activity so if you are just checking HR on the widget the built in OHR will be used.
-
@Audaxjoe yes did a recorded walk with in the settings HR monitor, put my watch in my pocket and no registration of the HR.
Next week I have a wahoo Tickr fit to use of a buddy of mine, hope this will work.Greetings and happy New year
-
@daniels770441 The only belt that has a memory function with Suunto watches is the Smartsensor Suunto sells. If the watch cannot detect BT signals from the belt it will not record.
Are you sure the watch is recognizing the belt. The HR symbol on the watch should not be just a heart but a heart symbol with a belt on either side.
Not this
Should look like this:
-
@Brad_Olwin thanks for this advice, downgraded the software to previous version and then connected the Wahoo Tickr fit and this works like a charm.
Going tomorrow ( if the weather allows it
) on a bike trip to check this setup out.
Did the downgrade because at night ( and sometimes overday) the HR stopped. With the previous version everything works fine.
Greetings from Belgium and thank you all for the support. -
Hello,
It works perfectly with my Wahoo Tickr fit so probably the magene HR band made an error.
Going to work with the wahoo then.
Thank you all for the support.Greetings from Belgium
