cadans sensor bluetooth

[andre 3sen]

I know that you can only connect a bike sensor to the suunto racer with Bluetooth.
But wenn i try that , the connection is there but only for speed , not for cadans .
I have to fill in de size off the wheel , but i don need it.
When i try it to my garmin venu watch , he find it as cadans.
Does some one have the answer.
It a magene speed/cadans sensor , whwn the lights shines red it for cadans , when it leds green its for speed.
At the bike it leds red.

Whats the solution ?

[Audaxjoe]

@andre-3sen I am not sure what unit you are using but I have a cadence and Speed sensor and both values are recorded by the watch.

You do need a combination unit, annoyingly Suunto only allow one bike pod connection.

[andre 3sen]

@andre-3sen thanks for the reply.
I have a magene speed and cadence sensor.
One with a red led for cadence , and one with a green led .
And both Ant+ and bluetooth, i only use the one with de red led , for cadence , but the watch registrate it as a speedsensor. ( even as the red led )
Its a pitty that suunto don’t have a compatible list for this kind of sensors.

[andre 3sen]

what kind of unit are you using ?

[Audaxjoe]

@andre-3sen I only have a cheap Amazon one. Can’t remember the make. I only use it on the indoor bike. And I hate using the indoor bike…
I did need to input the wheel dimensions but in my experience this is totally normal with a wheel speed sensor.

I don’t use it outdoors with GPS.

[isazi]

@andre-3sen I had the same magene sensor but I gave it away, so cannot check (it was working when I had it).

[andre 3sen]

@Audaxjoe , Thanks.
De speed sensor led green and is speed and works.
De Cadance leds green and doesn"t connect .
Also wenn i change the batterie and the red leds goes green the same effect , no connection with the cadence.
So i gone a buy an other cadence sensor , hopes the garmin with blue tooth works.