Suunto 5
-
@Dušan-Ković Probably not a bad idea but… if you have more than one watch as do I, I would want the setting toggled. Better yet, the app could detect you have a watch with no barometer and automatically correct. Maybe this should be added as a feature suggestion?
-
@Brad_Olwin I don’t have two watches, I only have S9B, but elevation correction would be good for users with non Baro watches. It should be implemented to SA. Also, users with Baro watches could check if altitudes are correct.
-
@Dušan-Ković said in Suunto 5:
@Brad_Olwin I don’t have two watches, I only have S9B, but elevation correction would be good for users with non Baro watches. It should be implemented to SA. Also, users with Baro watches could check if altitudes are correct.
The correction for Altitude is less precise than the barometric watches, I have checked this many times on Training Peaks. It depends on the filters are algorithms used.
-
One little remark regarding the strap. During sport activity the watch should be worn 2 fingers above the wrist bone to get good HR reading. For some users due to this position the strap could be too short or on the limit, therefore slight increase of strap length could be useful.
-
Hi!
I am a new Suunto 5 user, and the watch keeps restarting and freezing after some minutes. The down arrow is displayed, and after a hard reset, the issue repeats after some minutes. Did software update to latest, not using movescount (only Suunto app).
Any suggestions?Many thanks.
KR -
The down arrow is displayed, and after a hard reset, the issue repeats after some minutes
What do you mean for hard reset, factory reset + re-flashing the FW ?
Maybe it’s a defective unit. Contact support via email
SVTS - 2.37.48
SSSWHR BARO Amber - 2.8.32
Samsung A5 2016 - Android 7.0
Samsung A33 2022 - Android 14 - One UI 6.1
Suunto App Android 4.103.5 beta
Suunto App IOs 2.39.1 (16998) beta on MBP M1 -
This post is deleted! -
@sartoric
Yep, soft-reset: upper right+left button for 12 sec
hard-reset: from Suntoolink to flash firmware again. -
@vicaroka
So the best option is to contact support -
@vicaroka This should not occur. If you have done a full factory reset you should contact support. The S5 is not recognized by MC so that doesn’t matter.
-
This post is deleted!
