Suunto race alti & baro
-
Hello, I hope you are well!!
So, since a few weeks ago my Suunto race goes crazy with altitude. It is adjusting good with fusealti (gps), but then it goes up and down even if I stay still. It does the same also if I adjust it manually. Not only a few meters, sometimes goes to + 100 or - 100m when is supposed to be 3m .
I tried the soft reset and also the hard reset and still the same problem. Anyone experienced similar issue? Or any recommendation on how to fix it?
Thank youu!! And happy trails
-
@Silviu-Adrian-Moise sounds like a defective Sensor! I would prefer to open a suunto Service ticket for repair in guarantie!
If it doesn't challenge you, it doesn't change you. #lifewithasthma #runwithasthma #nevergiveup #pushinglimits #adventurestartshere Suunto D9, 9 Baro, 9 Peak, Vertical Ti, Race , Race s Courtney, SA (Beta) AndroidđđŒđ§â·ïžđ”
-
@Silviu-Adrian-Moise try water with a bit of soap for a couple of hoursâŠ
It solved by baro problems (but mine was stuck in the same altitudeâŠ) -
@claudiotereso thank you for the reply. I tried it but still the same problem
-
@GiPFELKiND thanks for the reply!! Yes, I am in contact with them to see whatâs wrong. But I canât send it right now, I am in the middle of big training blockâŠ
-
@Silviu-Adrian-Moise
Did you try a fridge test?
https://forum.suunto.com/post/42684
It may give some more proofs for a faulty sensor (once sure you have well cleaned the sensor with warm water, etcâŠ) -
My Race works the same way. I honestly think the altitude was temperature sensitive, and there is even mention of this in some of the manuals for some Suunto plus apps. I donât pay much attention to it though use it though as I live in a very flat place, I only care about barometric pressure and that does not vary.
-
@TitaniumDave yes mine is the same. I have done quite some trials and every time temperature does affect the altitude. Once I put it on my hand altitude starts decreasing slowly as the watch warms up. If I then place it back on a table, the altitude starts increasing again. Same with wind, impossible to get a good altitude track.
I am using the Race in stainless steel and black. Perhaps the titanium version is more stable? Who knows
I tried and tried to get a good stable altitude reading, but now starting to realize I am battling this for nothing
-
@spardic I tried everything. But the same problem has been going on for months. I think itâs a software problem.
-
If youâre wondering why altitude reading changes with the temperature, this might be helpful:
https://airplaneacademy.com/why-and-how-much-temperature-affects-altimeter-readings/
-
@Ćukasz-Szmigiel said in Suunto race alti & baro:
If youâre wondering why altitude reading changes with the temperature, this might be helpful:
https://airplaneacademy.com/why-and-how-much-temperature-affects-altimeter-readings/
that is related to the air temperature, not the temperature of the sensor that changes depending if you wear the watch or not
-
@Stefano-M64 the internal sensor of the watch canât measure the ambient temperature without it being influenced by the body heat. If youâre going to cycle between having a watch on your hand or on the table or on the handlebar, its altitude readings will change due to changes of internal sensorâs temperature.
This is why thereâs fusedalti, but it canât work reliably if the watch temperature fluctuates abruptly.
-
@Ćukasz-Szmigiel yes, I know, but the link you shared has nothing to do with thatâŠ
-
I think that the algorithm that changes from baro to alti mode automatically is not doing its job good enough. I have no way of knowing this for sure, but my guess is that itâs not the same algorithm that is used in other watches. I had much better results outside of activity with Suunto 9 Peak, Suunto 9 baro and ambit3 peak.
I wear my Race 24/7 and almost every morning I see altitude almost 50m more than the night before. During the activity, itâs very good, altitude is mostly spot on, but I have also seen crazy ascent values (like more than 50% more) few times (but that is not so uncommon with Suunto watches I guess).
-
@spardic said in Suunto race alti & baro:
Once I put it on my hand altitude starts decreasing slowly as the watch warms up. If I then place it back on a table, the altitude starts increasing again.
BTW, I tested that on my Race, found no differences in both altitude and pressure
-
@Silviu-Adrian-Moise Hello, Iâve had the same problem since yesterday, the altitude is going crazy even when stopped, and counting the ascent. And not just when active, even when staying at home without moving the altitude goes up and down. I already had the problem several months ago, and after trying everything, I had to fight with Suunto to get a replacement. So now Iâm doing a test today, and itâs going back to the store.
