Race misbehaving in multiple ways

[halajos]

I was trying to use the ZonSense S+ app on my SR the first time today. I vent out ton the trails, set up the watch with route navigation enabled, and activated ZoneSense. I also had Ultra Walking activated. I started the activity and realized I forgot to set a target HR zone, so I paused the activity and set that. This was within the first few minutes of the activity. The ZoneSense app didn’t display much data, I assumed it was because of the 10 minute period to get HR stabilize. But even after 10 minutes the app didn’t show my zone. It didn’t show NGP either. Then I realized, that the HR zones ring around activity data displays is stuck at green. In addition, my route selected for navigation was 32k but the navigation display showed much less. When I reached the end of remaining distance shown on the navigation screen, the route was reset, showing the total 32k to be ahead of me. The route I ran had crossed itself at two places, and my starting point was one of those points. This may be a contributing factor to the navigation display issue. I haven’t experienced this before, not even with self-crossing routes. I don’t know if these issues are inter-related, or related to pausing and enabling HR target mid-activity, might be. The issues with HR zone ring and ZoneSense seem to be related. Anyone experienced anything like that?
I sent the logs to Suunto, I would be thankful if forum moderators could help to report this. I took some pictures about the issue:

[Danny poleg]

@halajos Sorry for the question
Did you use a suitable heart rate strap?

[halajos]

@Danny-poleg said in Race misbehaving in multiple ways:

@halajos Sorry for the question
Did you use a suitable heart rate strap?

Yes, of course. And I have ZoneSense post-analysis in SA.

[halajos]

Apparently, I’ve got increased battery drain during the night after experiencing this error.

[halajos]

I did a couple of tests and was able to reproduce most of the issues. I think there are two bugs.

• When ZoneSense S+ is used together with UltraWalking S+, then ZoneSense doesn’t show the time spent in each zone (showing – instead).
• When ZoneSense S+ is used together with target HR zone, then the coloured circle around exercise data display and the arrow indicating the current HR get disconnected (colored circle gets stuck).