Not Vibrating & option limited to just 'On-Off'.

[isazi]

@Sergei-Ladeishchikov I can ask if this is expected or not, but during summer I’m not sure an answer will be provided.

[Sergei Ladeishchikov]

@isazi The most important thing is that Suunto is aware of the problem and can fix it with future updates)

[Ashish Bhattarai]

@Sergei-Ladeishchikov, @isazi isazi, @surfboomerang

Thanks for you suggestions but vibration still didn’t work after fully charging and also after a hard reset.

‘Vibration’ option under Settings-General-Tones-General, only shows a ‘on-off’ option, NOT ‘‘Buttons-off’, All-off’, ‘All-on’. Could this be a firmware version issue? Do you think it’ll help if I can roll back to a previous version?

Watch: Peak 9

[isazi]

Reported as a bug

[Ashish Bhattarai]

@isazi hi! Do you think this will be followed up by someone?
No vibration is bothering me a lot.

[isazi]

The issue that vibration is disabled when the watch battery is below 10% is being investigated.

[Ashish Bhattarai]

@isazi the issue is actually: No vibration at all, even when 100% charged.

[surfboomerang]

@Ashish-Bhattarai do you get a short vibration when you reboot the watch? It could be hardware related.

[Ashish Bhattarai]

@surfboomerang when I power off and bring it back on, it did vibrate for a short while!

[surfboomerang]

@Ashish-Bhattarai Great, hardware seems to work then.
Just make sure you didn’t enabled the “power saver” option and “Do not disturb” option".