Attivazione FusedAlti

freeheeler

@gi0vanni
I will try tonight. It’s easy, just set manually a completely wrong altitude, start an activity immediately that lasts longer than 15min and it will be visible if FusedAlti works or not

freeheeler

@gi0vanni
I could try during lunch. support is right

I’ve set my watch manually to 4’444m and after around 16min, it was corrected to 442m.

Egika

@freeheeler so the only use of manual calibration is when training at altitude with no or poor GPS reception…
Technically totally makes sense to me.

@freeheeler Thank you for trying, mine is at home and I couldn’t try it

Mff73

@freeheeler said in Attivazione FusedAlti:

@gi0vanni
I could try during lunch. support is right

I’ve set my watch manually to 4’444m and after around 16min, it was corrected to 442m.

And what does the altitude graph look like after saving in such case?

freeheeler

@Mff73

Egika

@Mff73 Fused alti is always adjusting backwards.

Mff73

@Egika
yes, i know :), but would like to see “how”

@Egika said in Attivazione FusedAlti:

@freeheeler so the only use of manual calibration is when training at altitude with no or poor GPS reception…
Technically totally makes sense to me.

you are totally right
i am still used to Spartan fused alti (blocked if manual altitude setup), AND, and old memories about some “progressive” adjustment at beginning of activity (don’t remember from where i have this memories).

freeheeler

@Mff73
I think it was like that also for S9B…
start and end alti could be better, but I assume it becomes better the longer the activity runs… and even then: with gnss comparison and correction, not bad

isazi

So much to learn in this forum ️