Zonesense difficult to understand
-
@VoiGAS Or you did not spend enough time near or above VO2M, which is hard to do. ZoneSense is not good for short ≤3 min intervals. I would use Power for those.
-
Your max HR is quite high, how did you determine it ?
For me, I used the formula 220 minus age, and increased it a bit, which gave me 158.
Zone values computed by the watch derived from this value, this why you find them so low.Given the sensations I have at 150 bpm, I can’t imagine trying to push higher, so a max HR of 158 seems reasonable for me.
For the moment, I just did two run with zonesense, first was very relax, 17Km in 2 hours, second was much more intensive, 10Km in 56mn.
Definitely, I did not have similar sensations , 2nd was much more difficult, but zonesense reports almost the same result, aerobic in 97% for the first, and 89% for the 2nd, which I find hard to trust! -
@luke55 I did two mountain bike rides (Sunday and Monday) of similar distance but of different difficulty.
Sunday was some punchy climbs which will spike my heart rate, Monday was mostly flat gravel.
Sunday
Monday
You can see that Sunday I was in anaerobic more than I was compared to Monday. That seems to correlate to the type of riding I was doing, and how winded I was.
-
@luke55 said in Zonesense difficult to understand:
Your max HR is quite high, how did you determine it ?
For me, I used the formula 220 minus age, and increased it a bit, which gave me 158.
Zone values computed by the watch derived from this value, this why you find them so low.Given the sensations I have at 150 bpm, I can’t imagine trying to push higher, so a max HR of 158 seems reasonable for me.
For the moment, I just did two run with zonesense, first was very relax, 17Km in 2 hours, second was much more intensive, 10Km in 56mn.
Definitely, I did not have similar sensations , 2nd was much more difficult, but zonesense reports almost the same result, aerobic in 97% for the first, and 89% for the 2nd, which I find hard to trust!You can try this to define HR zones:
https://moncoachdetriathlon.com/ressources-gratuites/calculateur-frequence-cardiaque/
Just put your email and you will be able dowload an Excel file and pdf file to compute your HR zones.
-
@luke55 said in Zonesense difficult to understand:
Your max HR is quite high, how did you determine it ?
For me, I used the formula 220 minus age, and increased it a bit, which gave me 158.
Zone values computed by the watch derived from this value, this why you find them so low.Given the sensations I have at 150 bpm, I can’t imagine trying to push higher, so a max HR of 158 seems reasonable for me.
For the moment, I just did two run with zonesense, first was very relax, 17Km in 2 hours, second was much more intensive, 10Km in 56mn.
Definitely, I did not have similar sensations , 2nd was much more difficult, but zonesense reports almost the same result, aerobic in 97% for the first, and 89% for the 2nd, which I find hard to trust!My max is set 3-5 bpm higher than the highest HR I had during the prior year. Since my late 30’s and early 40’s my Max has dropped from the low to mid 190’s. I do not know what your baseline fitness is. I have been training and racing ultras for the last 13 years.
-
Quite strange for me also:
According to publication on facebook:Suunto ZoneSense
🟢 Aerobic (green) – covering Z1–Z2
🟡 Anaerobic (yellow) – Z3–Z4
VO2max (red) – everything beyond anaerobic threshold (Z5).For me SuuntoSens mesured:
151bpm for VO2max (provided by suuntosens)
140bpm for z3-24 (anaerobic) (provided by suuntosens)But 170bpm during 13 minutes are considered in z3-z4 on SuuntoSens graph.
Over 140 is yellow : ok
But over 151 is not red: ko
-
@Antoine Looks like Zonesense just takes the HR when entering a zone. In your case the two peaks were when your heartrate was rather low (so not really in sync).
If that really is the way it works, then its rather useless because it will be wrong due to lag or other effects.
For me Zonesense looks more like a Proove of Concept than an actual working feature… -
As far I understand, zonesense is based on HR variability between beats and and this can only be measured with a chest HR sensor (it measures milliseconds differences between beats).
According to Suunto/MoniCardi this variability correlates with the lactate concentration in the blood, so the DDFA index is a indirect measure of lactate.If you look at the @Antoine graph above you can see that between 36’ and 48’ HR goes down but zonesense starts to show red peaks of VO2 max. This is because between 20’ and 36’ there was an intense activity and lactate started to accumulate rapidly.
Another example is in @Todd-Danielczyk graph, look at the end, HR goes down but zonesense shows that you are in VO2max, lactate is high and certainly Todd was exhausted at the end.
I have installed zonesense in my SR watch and I think this is a valuable tool but we need to get used to it.
-
@alebalbis Spot on assessment of how Zonesense can be used.
*also you are right, I was exhausted as I recovered from that one
-
@VoiGAS said in Zonesense difficult to understand:
@Antoine Looks like Zonesense just takes the HR when entering a zone. In your case the two peaks were when your heartrate was rather low (so not really in sync).
If that really is the way it works, then its rather useless because it will be wrong due to lag or other effects.
For me Zonesense looks more like a Proove of Concept than an actual working feature…That is not how ZoneSense works. Have you watched the video? Have you read the peer-reviewed manuscripts published in scientific journals? Have you read the white paper? Please stop speculating on what you think is happening. Perhaps educate yourself instead of making statements that are completely incorrect. I have replied to you many times stating this is not a measure of HR, so have others. It is not meant to follow HR nor is the measurement based on HR. It is based on relationships between IBI and in this manuscript, has been tested far more scientifically than anyone on this forum including me is likely to do. You refuse to acknowledge this. I am fine with you being skeptical of using it but understand how the feature works prior to continuing to assume it is synced to HR!
Kanniainen et al. - 2023 - Estimation of physiological exercise thresholds based on dynamical correlation properties of heart r.pdf
